Column Entries Used in the MAC (cont)

TM56625-2694-13&P

The

appropriate work time figures will be shown for each level.

number of man-hours specified by the work time figure represents the

average time required to restore an item (assembly, subassembly,

module, end item, or system) to a serviceable condition

component,

includes

under typical field

This time

conditions.

operating

preparation time, troubleshooting time, and quality assurance/quality control time, in addition

to the time required to perform the specific tasks identified for the maintenance functions

authorized in the maintenance allocation chart. The symbol designations for the various

maintenance levels are as follows:

C----- Operator or Crew

O -----Organizational Maintenance

F ----Direct Support Maintenance

H -----General Support Maintenance

D -----Depot Maintenance

e. Column 5, Tools and Equipment. Column 5 specified, by code,

those common tool sets

(not individual tools) and special tools, test

and support equipment required to perform the designated function.

Column 6, Remarks.

This column contains a letter code in

alphabetical order which is keyed to the remarks contained in Section

IV.

B-4 Column Entries Used in Tool and Test Equipment Requirements.

Column 1, Tool or Test Equipment Reference Code. The tool

with a maintenance

and test equipment reference code correlates

function on the identified end item or component.

The lowest

Column 2 , Maintenance Level.

level

maintenance authorized to use the tool or test equipment.

c. Column 3, Nomenclature.

Name or identification

of the tool

or test equipment.

d. Column 4, National\NATO Stock Number.

NATO

The National or

stock number of the tool or test equipment.

column 5, Tool Number.

The manufacturer's part number.

B-3

Change 1