TM 5-6350-275-24&P
a. See Figure 2-4. If the cleaning kit has never been used, remove the two triangular inserts (1) from the cleaning
diskette (2).
b. Moisten the cleaning diskette with the disk cleaning fluid.
c. Open the floppy diskette drive door (3) and insert the cleaning diskette. Rotate the locking lever (4) and the
diskette drive will activate.
d. Allow the drive to run for 10 to 15 seconds.
e. Record cleaning on the cleaning diskette label. Discard cleaning diskette after 13 uses, or if diskette becomes
discolored.
2-12. For cleaning and tightening of the UPS battery terminals and connectors, refer to SAIG.
Section V. UNIT TROUBLESHOOTING PROCEDURES
2-13. SCOPE. There are no troubleshooting procedures at the unit level for maintenance.
Section VI. UNIT MAINTENANCE PROCEDURES
2-14. SCOPE. There are no maintenance procedures at the unit level of maintenance.
Section VII. PREPARATION FOR STORAGE OR SHIPMENT
2-15. GENERAL. There are no special security procedures or special preservation, packaging, packing, marking, or
shipping requirements. Because of the purpose and function of the ICIDS equipment, the requirement for storing the
equipment is not anticipated or expected. The ICIDS will be operational as long as the activity on the installation remains
operational. If there is a base closure, the ICIDS might be administratively stored until shipping and delivery orders were
prepared. In this event, the following storage instructions apply:
2-16. ADMINISTRATIVE STORAGE.
Placement of equipment in administrative storage should be for short periods of time when a shortage of
maintenance effort exists. Items should be in mission readiness within 24 hours or within the time factors as
determined by the directing authority. During the storage period appropriate maintenance records will be kept.
Before placing equipment in administrative storage, current maintenance services and Equipment Serviceable
Criteria (ESC) evaluations should be completed, shortcomings and deficiencies should be corrected, and all
applicable Modification Work Orders (MWOs) should be applied.
Storage site selection: Inside storage is preferred for items selected for administrative storage. If inside storage is
not available, trucks, vans, conex containers, and other containers may be used.
2-7/(2-8 Blank)
