TM5-6350-264-14&P-6
NAVELEX EE181-AA-OMI-07A/E121 DT-545
TO 31S9-2FSS9-1-6
CHAPTER 1
INTRODUCTION
Section I. GENERAL
destruction of Army materiel to prevent enemy use are
1-1. SCOPE. This manual is for your use in operating
contained in TM 750-244-3.
and maintaining the Grid Wire Sensor (GWS) Model DT-
545/FSS-9(V) in its operational environment. The GWS
1-5. QUALITY ASSURANCE/QUALITY CONTROL.
is an integral part of the Joint Services Interior Intrusion
Detection System (J-SIIDS). For information on the
There are no Quality Assurance/Quality Control technical
major assemblies of J-SIIDS, refer to the applicable
manuals applicable to this equipment.
manual listed in appendix A.
1-6. REPORTING
EQUIPMENT
IMPROVEMENT
1-2. MAINTENANCE FORMS AND RECORDS.
RECOMMENDATIONS (EIR). EIR's will be prepared on
Equipment maintenance forms and procedures for their
Standard Form 368, Quality Deficiency Report.
use are contained in DA Pamphlet 738-750, the Army
Instructions for preparing EIR's are provided in DA
Maintenance Management System (TAMMS).
Pamphlet 738-750. EIR's should be mailed directly to
Commander, U.S. Army Troop Support Command,
1-3. ADMINISTRATIVE STORAGE. Instructions for
ATTN: AMSTR-QX, 4300 Goodfellow Blvd., St. Louis,
administrative storage are contained in TM 740-90-1.
Missouri 63120-1798. A reply will be furnished directly to
you.
1-4. DESTRUCTION OF ARMY MATERIAL
TO
1-7. EQUIPMENT
SERVICEABILITY
CRITERIA
PREVENT ENEMY USE. Instructions for the
(ESC). This equipment is not covered by an ESC.
Section II. DESCRIPTION AND DATA
1-8. DESCRIPTION. The GWS consists of a wire grid
1-9. TABULATED DATA.
in four inch squares and a steel chassis (fig. 1-1)
containing a component mounting plate, a terminal strip,
a. Identification Data. An identification plate (Fig. 1-
2) is located on the inside front cover.
a pry-off alarm switch, and a cover tamper alarm switch
(TAS). The chassis has a removable cover and an
b. Equipment Characteristics.
access hole where interconnecting wiring is brought in
through conduit. The wire grid is made of continuous
(1) GWS Assembly
horizontal and vertical wires and can cover up to 160
square feet in any shape. Depending on the barrier
Weight ............................... 6.7 pounds (3.1 kg)
material, the grid wire is stapled directly to the barrier or
'to 'a foundation board that is secured to the barrier.
Dimensions (overall)
Fire-resistant panels are then installed over the grid wire
for protection against daily abuse and visual detection.
Height ............................. 2.68 inches (6.8 cm)
Width .............................. 4.30 inches (11 cm)
Change 1 1-1
