Connector Receptacle Removal and Replacement

TM 11-7010-201-40-5/ET821-AA-MMI-050/E154 MTS/T O 31S5-2TSQ73-2-5

(1) Insert extraction tool (Winchester No. 107-1012 or equivalent) into the appropriate connector pin (5) cavity.

(2) Remove connector pin (5) and attached wire from the wire side of connector receptacle (4).

NOTE

If it is necessary to remove wire from connector pin (5), cut off wire as close to pin end as possible.

b. Replacement. Perform the following procedure to replace any or all of the connector receptacle pins (5).

NOTE

If old connector pin has been removed, strip just enough insulation from wire to allow it to bottom out in

the connector pin barrel. Insert wire into connector pin barrel until it bottoms out. Using crimp tool

(Daniels AFM8, M22520/2-01 or equivalent) and positioner (Daniels K1-6-8SM or equivalent), insert pin

(5) and wire into crimp tool until it bottoms out in the well of crimp tool. Squeeze handles of crimp tool

until completely closed to crimp wire and pin (5).

(1) From wire side of connector receptacle, insert wire and pin (5) into appropriate connector receptacle cavity,

using insertion tool (Winchester No. 107-1011 or equivalent).

NOTE

Ensure that connector pin (5) is fully seated into connector receptacle (4).

(2) Close front panel (17), and secure with three knurled captive screws.

5-20. Connector Receptacle Removal and Replacement. (See figure 5-1.) Connector receptacle (4) may be removed

and replaced by performing the following procedures.

a. Removal. Perform the following procedure to remove connector receptacle (4).

(1) Perform connector receptacle pin (5) removal procedure (para 5-17) for each of the connector pins (5).

(2) Remove four self-locking nuts and screws from connector receptacle (4) and remove receptacle.

b. Replacement. Perform the following procedure to replace connector receptacle (4).

(1) Perform connector receptacle pin (5) replacement procedure (para 5-17) for each of the connector pins.

5-14