H78 STRING AND DOUBLE ENTRY LIST, DEFINITION OF FIELDS-continued

TM 11 -7010-201-40-2/ET821 -AA-MMI-020/E1 54 MTS/T.O. 31 S5-2TSQ73-2-2

H78 STRING AND DOUBLE ENTRY LIST, DEFINITION OF FIELDS - Continued

11. Spc. Inst. - A code which indicates that a wire must be given special attention as follows:

A. Direct routing, no service loops, no harnessing.

B. See general notes or instruction pages.

C. See general notes or instruction pages.

D. See general notes or instruction pages.

E. See general notes or instruction pages.

F. See signal description.

G. This connection does not go directly to the "TO" connector but intersects a line going to the "TO" connector.

H. See special routing page.

I. Junction point for multilayer laiminated board (MLB) connection.

J. Denotes a buss reference point.

K. Blank out "TO" connector and pin.

L. Will cause a single name of three characters or less to be entered in the string list.

M. Will cause a record to be omitted from the string list. (This record will print in the connector list.)

N. Will suppress printing the wire identification in the harness string and double entry list.

P. Will cause the equation to be used as the signal name only for sorting purposes in the string list.

Q. Will cause an equation record to be omitted from logic listing.

R. Will suppress printing the "FROM/TO" pin number in the string and connector list.

S. Do not move record number to the identification field for an ADD transac tion in the harness string and double

entry only. (Use only when adding a file.)

T. Twist wire code.

U. Not available.

V. See general notes or instruction pages.

W. Fixed wire length submitted.

X. Sequence of string is to be left as is.

Y. See general notes or instruction pages.

Z. Will suppress printing of the "FROM" pin.

12. Signal - An alphanumeric signal name, mnemonic where feasible, which identifies one specific function. from

another.

13. String Seq. No. - A number which, in conjunction with SIGNAL, allows a signal string to be consistently printed in a

given order.

14. Signal Description - A written description or name of a signal or voltage.

15. ECO No. - A letter number combination to show the Engineering Change Order level of that particular wire list

record.

Drawing No.

WL10281449

Rev. G, sheet 3