Click here to make tpub.com your Home Page

Page Title: Connector J7 Contact Removal and Replacement
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 11 -7010-201-40-1/ET821 -AA-MMI-010/E154 MTS/T O 31S5-2TSQ73-2-1
(6) Install connector into front panel; secure with four screws and nut ring (figure 3-10).
(7) Secure front panel of MTS to chassis following procedure in paragraph 3-12.
3-19. Connector J7 Contact Removal and Replacement. Perform the following procedures to remove
and replace any of the contacts in front panel connector J7.
a. RemovaL Remove contact from connector J7 as follows:
(1) Gain access to rear of MTS front panel following procedure in paragraph 3-12.
(2) Insert extraction tool (Winchester 107-1012 or equivalent) into appropriate connector cavity from mating side of
connector.
NOTE
While inserting the extraction tool, rotate the tool in a circular pattern.
(3) Remove contact and attached wire from cable side of connector.
(4) To disconnect contact from its wire, cut wire as close to contact as possible.
b. Replacement Replace contact in connector J7 as follows:
(1) Strip just enough insulation from wire to allow it to bottom out in barrel of contact.
(2) Insert wire into contact until it bottoms out; stripped wire should be visible through contact
inspection hole, and wire insulation should butt against contact.
(3) Using crimp tool (Winchester 107-0610 or equivalent) and positioner (Winchester 107-0603 or equivalent),
insert contact and wire into well of crimp tool.
(4) To crimp contact and wire, squeeze handles of crimp tool until completely closed.
(5) Using insertion tool (Winchester 107-1011 or equivalent), insert contact and wire into appropriate connector
cavity from wiring side of connector.
NOTE
Ensure that contact is fully seated in connector.
(6) Secure front panel of MTS to chassis following procedure in paragraph 3-12.
3-28

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business