|
|
TM 11-6625-646-15
SECTION I
INTRODUCTION AND DESCRIPTION
1-2.4.
Reporting
Equipment
Improvement
1-1. General
Recommendations (EIR)
EIR's will be prepared using DA Form 2407,
1-2. Scope
(Maintenance Request). Instructions for preparing EIR's
This manual describes Test Set, Stabilization
are provided in TM 38-750, the Army Maintenance
Equipment TS-1894/ASM (fig. 1-1) and provides
Management System. EIR's should be mailed direct to
instruction for operation, maintenance, and functioning
Commander, US Army Electronics Command, ATTN:
of the equipment.
It includes the maintenance
DRSEL-MA-Q, Fort Monmouth, NJ 07703. A reply will
allocation chart and illustrated parts breakdown. Unless
be furnished direct to you.
otherwise indicated, all references to the TS-1894/ASM
apply to SAS Bench Test Set part Nos. 114E5987-4 and
1-2.5. Administrative Storage
114E5987-8.
Administrative storage of equipment issued to and used
by Army activities shall be in accordance with TM 740-
1-2.1. Indexes of Publications
90-1.
a. DA Pam 310-4. Refer to the latest issue of DA
Pam 310-4 to determine whether there are new editions,
1-2.6. Destruction of Army Electronics Materiel
changes, or additional publications pertaining to the
Destruction of Army electronics materiel to prevent
equipment.
enemy use shall be in accordance with TM 750-244-2.
b. DA Pam 310-7. Refer to DA Pam 310-7 to
determine whether there are modification work orders
1-3. Purpose of Equipment
(MWO's) pertaining to the equipment.
1-4.
1-2.2. Forms and Records
The test set tests the Stability Augmentation System
a. Reports of Maintenance and Unsatisfactory
(SAS) amplifier installed in CH-47 helicopters. The test
Equipment. Maintenance forms, records, and reports
set determines that a SAS amplifier or its plug-in cards
which are to be used by maintenance personnel at all
perform according to minimum serviceability standards.
maintenance levels are listed in and prescribed by TM
Test cables and receptacles and air pressure
38-750.
connections are provided for SAS amplifier tests. In test
b. Report of Packaging and Handling Deficiencies.
set 114E5987-8, adapter 114V3058-1 (roll gyro
Fill out and forward DD Form 6 (Packaging
simulator) is provided Three CARD TESTER
Improvement
Report)
as
prescribed
in
AR
receptacles, marked DEM/MOD, AMPLIFIER, and
70058/NAVSUPINST
4030.29/AFR
71-13/MCO
CALIBRATION, are installed on the front panel. In
P4030.29B, and DLAR 4145.8.
addition, test points (test jacks) are provided for
c. Discrepancy in Shipment Report (DISREP) (SF
measuring input, output, and signal voltages at the
361). Fill out and forward Discrepancy in Shipment
receptacle of the SAS amplifier. Test jacks are also
Report (DISREP) (SF 361) as prescribed in AR 55-
provided for measuring resistances or checking relay
38/NAVSUPINST
4610.33B/AFR
75-18/MCO
operation on its plug-in calibration card.
P4610.19C and DLAR 4500.15.
1-5. Adapter Switch Operation
An adapter switch is located behind a warning
1-2.3. Reporting of Errors
instruction panel on the front panel. The switch is
You can help improve this manual by calling attention to
factory-set at B for testing CH-47 SAS amplifiers.
errors and by recommending improvements and stating
Position A is used for testing SAS amplifiers for other
your reasons for the recommendations. Your letter or
helicopters.
Operating the switch from B to A
DA Form 2028 (Recommended Changes to Publications
transposes the pitch and roll channel circuits of the test
and Blank Forms)should be mailed direct to
set. It also changes the amplifier operating voltage
Commander, US Army Communications & Electronics
output of the test set from 115 to 26 volts ac.
Materiel Readiness Command, ATTN: DRSEL-MA-Q,
Fort Monmouth, NJ 07703. A reply will be furnished
direct to you.
Change 4
1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |