Column Entries. - TM-11-6625-3024-140104

TM 11-6625-3024-14/EE641-AC-MMA-010/E154 SYSEX/TO 33AA50-5-1-1

Army. Overhaul does not normally return an item

maintenance allocation chart. Subcolumns of

to like new condition.

Column 4 are as follows:

k. Rebuild. Consists of those services/actions

Operator/Crew

necessary for the restoration of unserviceable

Organizational

equipment to a like new condition in accordance

Direct Support

with original manufacturing standards. Rebuild is

the highest degree of materiel maintenance applied

General Support

to Army equipment. The rebuild operation includes

Depot.

the act of returning to zero those age

e. Column 5, Tools and Equipment. Column 5

measurements (hours, miles, etc.) considered in

specifies, by code, those common tool sets (not

classifying Army equipments/components.

individual tools), and special tools, test, and support

B-4. Column Entries.

equipment required to perform the designated

function.

a. Column 1, Group Number. Column 1 lists

f. Column 6, Remarks. Column 6 contains an

group numbers, the purpose of which is to identify

alphabetic code which leads to the remark in

components, assemblies, subassemblies, and

Section IV, Remarks, which is pertinent to the item

modules with the next higher assembly.

opposite the particular code.

b. Column 2, Componend/Assembly. Column 2

contains the noun names of components,

B-5. Tool and Test Equipment Requirements

assemblies, subassemblies, and modules for which

(SectIon III).

maintenance is authorized.

a. Tool or Test Equipment Reference

c. Column 3, Maintenance Function. Column 3

Code. The numbers in this column coincide with

lists the functions to be performed on the item

the numbers used in the tools and equipment

listed in Column 2. When items are listed without

column of the MAC. The numbers indicate the

maintenance functions, it is solely for the purpose

applicable tool or test equipment for the

of having the group numbers in the MAC and

maintenance functions.

RPSTL coincide.

b. Maintenance Category. The codes in this

d. Column 4, Maintenance Category. Column 4

column indicate the maintenance category allocated

specifies by the listing of a worktime figure in the

the tool or test equipment.

appropriate subcolumn(s), the lowest level of

c. Nomenclature. This column lists the noun

maintenance authorized to perform the function

name and nomenclature of the tools and test

listed in Column 3. This figure represents the active

equipment required to perform the maintenance

time required to perform that maintenance

functions.

function at the indicated category of maintenance.

d. National/NATO Stock Number. This column

If the number or complexity of the tasks within the

lists the National/NATO stock number of the

listed maintenance function vary at different

specific tool or test equipment.

maintenance categories, appropriate worktime

e. Tool Number. This column lists the

figures will be shown for each category. The

manufacturer's part number of the tool followed by

number of task-hours specified by the worktime

the Federal Supply Code for manufaccturers (5-

figure represents the average time required to

digit) in parentheses.

restore an item (assembly, subassembly, component,

module, end item or system) to a serviceable

B-6. Remarks (Section IV).

condition under typical field operating conditions.

a. Reference Code. This code refers to the

This time includes preparation time,

appropriate item in Section II, Column 6.

troubleshooting time, and quality assurance/quality

b. Remarks. This column provides the required

control time in addition to the time required to

explanatory information necessary to clarify items

perform the specific tasks identified for the

appearing in Section II.

maintenance functions authorized in the

B-2