REMOVAL - TM-11-6625-2976-400115

TM 11-6625-2976-40

2-42. BATTERYCHARGER LOW VOLTAGE SUPPLY CABLE REPLACEMENT. (CONT)

REMOVAL

1. Remove four screws (1), Iockwashers (2), and move circuit board A1 (3) to side.

2. Unsolder tan wire (4) from standoff (5), black wire (6) from standoff (7), and green wire (8)

from ground lug (9).

3. Push strain relief bushing (10) off cable(11) from inside of chassis.

4. Remove cable (11).

5. Loosen two screws (12) on connector shell (13) and unscrew connector shell from electrical

connector (14).

6. Unsolder black wire from terminal A, tan wire from terminal B, and green wire from terminal C

on electrical connector (14) as shown in detail C.

7. Remove electrical connector (14).

INSTALLATION

1. Prepare one end of cable (11) as shown in detail A.

2. Push prepared end of cable (11) into chassis,

3. Solder green wire (8) to ground lug (9), black wire (6) to standoff (7), and tan wire (4) to

standoff (5).

4. Position strain relief bushing (10) on cable (11) near chassis wall and push into place.

5. Position circuit board Al (3) on standoffs and install four screws (1) and lockwashers (2).

6. Prepare remaining end of cable (11) as shown in detail B.

7. Push prepared end of cable(11) through connector shell (13) as shown in detail C.

8. Solder black wire (6) to terminal A, tan wire (4) to terminal B, and green wire (8) to terminal C

on electrical connector (14).

9. Screw connector shell (13) to electrical connector (14).

10. Tighten two screws (12) on connector shell (13).

FOLLOW-ON MAINTENANCE: Install battery charger cover (para 2-37).

2-87/(2-88 blank)