Appendix B. COMPONENTS OF END ITEM LIST

APPENDIX B

COMPONENTS OF END ITEM LIST

Section I. INTRODUCTION

b. National Stock Number. Indicates the National

B-1.

Scope

stock number assigned to the item and which will be

This appendix lists integral components of and basic

used for requisitioning.

issue items for the AN/UKM-5 to help you inventory items

c. Description. Indicates the Federal item name

required for safe and efficient operation.

and, if required, a minimum description to identify the

B-2.

General

item. The part number indicates the primary number

This Components of End Item List is divided into the

used by the manufacturer, which controls the design and

following sections:

characteristics of the item by means of its engineering

a. Section II. Integral Components of the End Item.

drawings, specifications, standards, and inspection

Not applicable.

These items, when assemblied,

requirements to identify an item or range of items.

comprise the AN/UKM-S and must accompany it

Following the part number, the Federal Supply Code for

whenever it is transferred or turned in. The illustrations

Manufacturers (FSCM) is shown in parentheses.

will help you identify these items.

d. Location. The physical location of each item

b. Section Ill. Basic Issue Items. Not applicable.

listed is given in this column. The lists are designed to

These are the minimum essential items required to place

inventory all items in one area of the major item before

the AN/UKM-5 in operation, to operate it, and to perform

moving on to an adjacent area.

emergency repairs. Although shipped separately packed

e. Usable on Code. Not applicable. "USABLE ON"

they must accompany the AN/UKM-5 during operation

codes are included to help you identify which component

and whenever it is transferred between accountable

items are used on the different models. Identification of

officers. The illustrations will assist you with hard-to-

the codes used in these lists are:

identify items.

This manual is your authority to

Code

Used on

requisition replacement BH, based on TOE/MTOE

f: Quantity Required (Qty Reqd). This column lists

authorization of the end item.

the quantity of each item required for a complete major

B-3.

Explanation of Columns

item.

a. Illustration. This column is divided as follows:

g. Quantity. This column is left blank for use during

(1) Figure number.

Indicates the figure

an inventory. Under the Rcvd column, list the quantity

number of the illustration on which the item is shown.

you actually receive on your major item. The Date

(2) Item number. The number used to identify

columns are for your use when you inventory the major

item called out in the illustration.

item.

B-1/(Next printed page is B-2)