TABLE 3-1. SELF-TEST SETUP PROCEDURES

TM 11-6625-2885-12/NAVAIR 16-35TS3614-1

OPERATIONAL SELF-TEST (Continued)

TABLE 3-1. SELF-TEST SETUP PROCEDURES

PROCEDURE

Remove cover of FLTS.

Remove transmitter 1A1 and receiver 1A3 assemblies from the cover,

and place down on ammo bay hatch cover.

Set ON/PWR switch to PWR (off).

Set STBY/OPR switch to STBY.

Remove cables W1, W2, W3 and W4 from the cover.

Connect cable W3 between video assembly 1A2 J3 and receiver

assembly 1A3 J1.

Connect cable W2 between video assembly 1A2 J2 and transmitter

assembly lA1 J1.

Connect cable W1 between video assembly 1A2 J1 and

AN/ALQ-136(V)1 LRU-1 1J7.

CAUTION

Semirigid cable W4 is easily damaged.

Do not bend cable W4.

Connect cable W4 between transmitter assembly 1A1 J2 and

receiver assembly 1A3 J2.

(This causes the transmitter assembly to route an attenuated RF

signal into the receiver assembly, simulating an operational set-up.)

Set CM set LRU-3 OPR/STBY/OFF switch to STBY

(refer to TM 11-5865-202-12.)

3-16