FLIGHT LINE TEST SET (FLTS) CONTROLS, INDICATORS, AND CONNECTORS

TM 11-6625-2885-1 2/NAVAIR 16-35TS3614-1

FLIGHT LINE TEST SET (FLTS) CONTROLS, INDICATORS, AND CONNECTORS

2-2. As discussed previously, the FLTS allows you to test the CM set at the

flight line, and shows you the operating status of the CM set.

RCV J3 connector -connects FLTS video assembly lA2 to FLTS receiver assembly

1A3 via cable W3.

XMT J2 connector - connects FLTS video assembly 1A2 to FLTS transmitter

assembly 1A1 via cable W2.

PWR indicator - when lit (green), indicates that +28V is supplied to video

assembly 1A2 power supplies.

GO/NO-GO indicator - when lit (green) indicates proper signal processing

between FLTS receiver (1A3), transmitter (1A1), and video (1A2) assemblies

during self-test, or between FLTS and CM set during equipment test.

JAM indicator - when lit (white), indicates that the RF power has reached

an acceptable level in either self-test or equipment test.

LAMP TEST/SELF-TEST switch - momentary switch that allows selection of LAMP

TEST or SELF-TEST and is in the center (off) position when no test is

required. In LAMP TEST position the GO/NO-GO and JAM lamps illuminate. In

SELF-TEST position signals are generated to check proper signal processing

between receiver (1A3), transmitter (1A1), and video (1A2) assemblies.

OPR/STBY switch - allows selection of STBY mode or OPR mode. In STBY mode

no test signal is generated. In OPR mode a test signal is generated for

either self-test or equipment test.

ON/PWR circuit breaker - allows application of +28V to the FLTS in the ON

position, and provides overcurrent protection.

PWR J1 connector - connects FLTS video assembly 1A2 to CM set 1J7 through

cable W1.

2-2