|
| |
TM 10-6630-236-13&P
C .............................................. Operator/Crew
O .............................................. Unit Maintenance
F............................................... Direct Support Maintenance
H .............................................. General Support Maintenance
D .............................................. Depot Maintenance
e. Column 5. Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual
tools) and special tools, TMDE, and support equipment required to perform the designated function.
f. Column 6. Remarks. This column shall, when applicable, contain a letter code, in alphabetic order, which
shall be keyed to the remarks contained in section IV.
B-4. Explanation Of Columns In Tool And Test Equipment Requirements, Section III.
a. Column 1. Reference Code. The tool and test equipment reference code correlates with a code used in
the MAC, section II, column 5.
b. Column 2. Maintenance Category. The lowest category of maintenance authorized to use the tool or
test equipment.
c. Column 3. Nomenclature. Name or identification of the tool or test equipment.
d. Column 4. National Stock Number. The National stock number of the tool or test equipment.
e. Column 5. Tool Number. The manufacturer's part number.
B-5. Explanation Of Columns In Remarks, Section IV.
a. Column 1. Reference Code. The code recorded in column 6, Section II.
b. Column 2. Remarks. This column lists information pertinent to the maintenance function being
performed as indicated in the MAC, section II.
SECTION II. MAINTENANCE ALLOCATION CHART
(1)
(2)
(3)
(4)
(5)
(6)
TOOLS
GROUP
COMPONENT/
MAINTENANCE
MAINTENANCE CATEGORY
AND
NUMBER
ASSEMBLY
FUNCTION
EQPT
REMARKS
C
O
F
H
D
01
TESTER,
INSPECT
0.1
FLASH POINT
REPLACE
0.2
OPEN CUP
REPAIR
0.5
1
A
B-3
|
