| |
TM 10-6630-235-13&P
C . . . . . . . . . . . . . . . . . . . . .
O
. . . . . . . . . . . . . . . . . . . .
F . . . . . . . . . . . . . . . . . . . . .
H . . . . . . . . . . . . . . . . . . . . .
D . . . . . . . . . . . . . . . . . . . . .
Operator/Crew
Unit Maintenance
Direct Support Maintenance
General Support Maintenance
Depot Maintenance
e.
Column 5. Tools and Equipment.
Column 5 specifies, by code, those common tool sets (not
individual tools) and special tools, TMDE, and support equipment required to perform the designated
function.
f. Column 6. Remarks. This column shall, when applicable, contain a letter code, in alphabetic
order, which shall be keyed to the remarks contained in section IV.
B-4. Explanation Of Columns In Tool And Test Equipment Requirements, Section III.
a.
Column 1. Reference Code. The tool and test equipment reference code correlates with a code
used in the MAC, section II, column 5.
b.
Column 2. Maintenance Category. The lowest category of maintenance authorized to use the tool
or test equipment.
c.
d.
e.
B-5.
a.
b.
performed as indicated in the MAC, section II.
Column 3. Nomenclature. Name or identification of the tool or test equipment.
Column 4. National Stock Number. The National stock number of the tool or test equipment.
Column 5. Tool Number. The manufacturers part number.
Explanation Of Columns In Remarks, Section IV.
Column I. Reference Code. The code recorded in column 6, Section II.
Column 2. Remarks. This column lists information pertinent to the maintenance function being
Section II. MAINTENANCE ALLOCATION CHART
(1)
(2)
(3)
(4)
(5)
(6)
GROUP
COMPONENT/
MAINTENANCE
MAINTENANCE LEVEL
TOOLS AND
NUMBER
ASSEMBLY
FUNCTION
UNIT
DS
GS
DEPOT
EQUIPMENT
REMARKS
C
O
F
H
D
01
TESTER FLASH POINT
INSPECT
0.3
CLOSED, TAG
REPLACE
0.3
REPAIR
1.51.0
1,2
A
B - 3
|