|
| |
TM 1-6625-736-13 & P
(7)
The usable on code, when applicable (see paragraph C-5, Special information).
(8)
In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for each
special tool, special TMDE, and other special support equipment. When density of equipment's supported
exceeds density spread indicated in the basis of issue, the total authorization is increased proportionately.
(9)
The statement "END OF FIGURE" appears just below the last item description in Column 5 for a given
figure in both Section II and Section III.
f.
QTY (Column (6)) The QTY (quantity per figure column) indicates the quantity of the item used in the breakout
shown on the illustration figure, which is prepared for a functional group, sub functional group, or an assembly. A
"V" appearing in this column in lieu of a quantity indicates that the quantity is variable and the quantity may vary
from application to application.
C-4. EXPLANATION OF COLUMNS (SECTION IV)
a.
-NATIONAL STOCK NUMBER (NSN) INDEX
(1)
STOCK NUMBER Column - This column lists the NSN by National Item Identification Number (NIIN)
sequence. The NIIN consists of the last nine digits of the NSN.
example: 5305-01-674-1467 - NIIN
When using this column to locate an item, ignore the first 4 digits of the NSN. However, the complete
NSN should be used when ordering items by stock number.
(2)
FIG. Column- This column lists the number of the figure where the item is identified/ located. The figures
are in numerical order in Section II and Section III.
(3)
ITEM Column - The item number identifies the item associated with the figure listed in the adjacent FIG.
column. This item is also identified by the NSN listed on the same line.
b.
PART NUMRER INDEX - Part numbers in this index are listed by part number in ascending alphanumeric
sequence (i.e., vertical arrangement of letter and number combination which places the first letter or digit of each
group in order A through Z, followed by the number 0 through 9 and each following letter or digit in like order).
(1)
CAGE Column - The Commercial and Government Entity (CAGE) is a 5-digit numeric code which is used
to identify the manufacturer, distributor, or Government agency, etc., that supplies the item. CAGE
consolidates the former H5 Federal Supply Code for Manufacturers (FSCM) and H8 Federal Supply Code
for Non-Manufacturers (FSCNM).
(2)
PART NUMBER - Column Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of
its engineering drawings, specifications standards, and inspection requirements to identify an item or range
of items.
C-6
|
