|
| |
TM 1-6625-736-13&P
SECTION V-MAINTENANCE PROCEDURES
4-14 MAINTENANCE PROCEDURES-GENERAL
4-14
When a maintenance procedure is required, it will usually involve removal of the part being repaired or replaced.
Removal procedures are given only to the extent necessary to repair or replace authorized parts.
4-15 SIGNAL GENERATOR PRINTED WIRING ASSEMBLY (PWA)
4-15
THIS TASK COVERS:
REMOVAL AND INSTALLATION
Initial Setup:
Workbench with ESD capability
Personnel Required:
TMDE Support Specialist
Tools and Equipment:
Tool Kit, Electricians
Parts/Materials:
Anti-static pad
Equipment Condition:
Unit disconnected, cover removed, Top Plate facing
up on workbench
CAUTION
This assembly contains parts sensitive to damage by ElectroStatic Discharge (ESD)
Use precautionary ESD procedures when touching, removing or inserting. Use static-free
material to wrap the assembly for shipment or storage.
GO TO NEXT PAGE
4-11
|
