Table 2-1. Operator's Controls. (cont)

TM 1-6625-735-14

Table 2-1.

Operator's Controls. (Cont)

CONTROL, INDICA-

TOR, TEST POINT, OR

CONNECTOR

FUNCTION

Provides monitoring capability for simulated SAS amplifier-dc

YAW RATE TEST Test

MH-60K

yaw rate gyro signal. When test set YAW RATE simulator mode selector

Point

switch is placed to SIM 1 or SIM 2, YAW RATE TEST test point is con-

nected to YAW RATE SIM test point.

YAW RATE Test Point

Provides monitoring capability for SAS amplifier-dc yaw rate gyro

MH-60K

output.

YAW 26VAC REF Test

Provides monitoring capability for 26 vac yaw demodulator refer-

MH-60K

Point

ence derived in SAS amplifier.

ROLL 26VAC REF Test

Provides monitoring capability for 26 vac roll demodulator refer-

MH-60K

Point

ence derived in SAS amplifier.

SAS SIG REF PITCH

Provides monitoring capability for command reference supplied by SAS ampli-

and ROLL/YAW Test

fier power supply. These test points are about 12.0 vdc relative to power

Points

ground.

Provides test

Computer Test Point

EH60A

UH-60A

UH-60L

EH-60A

UH-60Q

points for monitoring SAS/FPS computer. Each test point labeling corresponds

Panel

to pin letters on SAS/FPS computer connectors J111, J121, and J139. Test

point panel also provides connectors J4, J5, and J6, which are used with cable

assemblies W4, W5, and W3 to connect test set to SAS/FPS computer.

2-28