| |
TM 1-4920-45813&P
4-39.
REMOVE AND REPLACE DIODE PLATE (Cont)
(Sheet 2 of 2)
4-39.1. REMOVAL
Holes in diode plate have plastic washers for insulation to prevent short.
a.
Remove two nuts (1), two connectors (2), two washers (3) four insulators (4) and two washers (5) from diode
plate (6) and two diodes (7).
b.
Desolder and remove two wires (8) from anode end of diode eyelet.
c.
Remove two screws (9) from bottom of chassis (10).
d.
Remove diode plate (6) from chassis (10).
4-39.2. INSTALLATION
a.
Mount diode plate (6) to chassis (10) using two screws (9) through bottom of chassis (10).
b.
Using solder (D5) solder wires (8) to anode end of diode eyelet.
c.
Install two diodes (7) through diode plate (6) using two washers (5), four insulators (4), two washers
(3),
two connectors (2), and two nuts (1).
4-39.3. FOLLOW ON MAINTENANCE
Performance check (para. 2-5)
END OF TASK
4-55
|