|
| |
TM 1-4920-458-13&P
Section II. Service Upon Receipt
SECTION CONTENTS
PARA
PAGE
GENERAL
3-6
3-3
3-6.
GENERAL
Visually check the exterior of the Pitot and Static Systems Tester for any apparent damage. Check contents to assure
that all components listed in the Repair Parts and Special Tools List (RPSTL) of this manual are enclosed and
undamaged.
Section III. Preventive Maintenance Checks And Services (PMCS)
SECTION CONTENTS
PARA
PAGE
GENERAL
3-7
3-3
CLEANING
3-8
3-3
FILLING OIL RESERVOIR
3-9
3-4
DRAINING THE OIL SUMPS
3-10
3-6
PERFORMANCE CHECKS
3-11
3-7
3-7.
GENERAL
Preventive maintenance for the Pitot and Static Systems Tester is covered by the following paragraphs as well as the
Notes and Cautions in Chapter 2, and information listed in Table 2-1. These Notes and Cautions, if followed, assure that
the equipment will be used in the proper manner.
3-8.
CLEANING
CAUTION
Use a soft cloth dampened with a solution of mild soap and water or isopropyl alcohol (D4) for cleaning.
a.
Keep equipment free of dirt and grease. Place protective cover over tester operator panel and external ports
when not in use.
b.
Clean load cells prior to use to assure good mating surfaces for the adapters.
3-3
|
