Tools and Test Equipment Requirements, Section III

ARMY TM 5-6675-309-14

MARINE CORPS TM 08840A-14/1

c. Column 3: Maintenance Functions. Column 3

and support equipment required to perform the desig-

lists functions to be performed on the items listed in

nated function.

Column 2.

f. Column 6: Remarks. Column 6 contains an al-

phabetic code referring to Section IV, Remarks, which

d. Column 4: Maintenance Category. Column 4

is pertinent to the item opposite the particular code.

specifies, by listing of a "work-time" figure in the

appropriate column(s), the lowest level of maintenance

D-4. Tools and Test Equipment Requirements, Section

authorized to perform the function listed in Column 3.

III.

This figure represents the active time required to per-

form that maintenance function at the indicated cate-

a. Column 1: Reference Code. The numbers in this

gory of maintenance. If the number or complexity of

column coincide with the numbers used in the tools and

the tasks within the listed maintenance function vary at

equipment column of the Maintenance Allocation

different maintenance categories, appropriate "work-

Chart.

time" figures will be shown for each category. The

b. Column 2: Maintenance Category. The codes in

number of man-hours specified by the work-time figure

this column indicate the maintenance categories allo-

represents the average time required to restore an item

cated.

(assembly subassembly, component, module, end item,

c. Column 3: Nomenclature. This column lists

or system) to a serviceable condition under typical field

tools, tests, and maintenance equipment required to

operation conditions. Subcolumns of the maintenance

perform the maintenance functions.

category are as follows:

d. Column 4: National/NATO Stock Number. This

General Support

column lists the National/ NATO Stock Number of the

Depot

specific tool or test equipment.

e. Column 5: Tools and Equipment. Column 5

e. Column 5: Tool Number. This column lists man-

specifies by code, defined in Section III, those common

ufacturing part number and Federal Supply Code for

tool sets not individual tools) and special tools, test,

Manufacturers (FSCM).

D-2