AC and DC Power Cable Repair

TM 11-7010-201-40-1/ET821-AA-MMI-010/E154 MTS/T O 31S5-2TSQ73-2-1

3-21. AC and DC Power Cable Repair. The ac and dc power cable repair consists of removing and replacing solder

contact connectors. The ac power cable contains a molded plug on one end which is non-repairable. Perform the

following procedure to remove and replace cable connector.

a. Removal. Remove cable connector as follows:

(1) Loosen two screws securing strain relief clamp, and slide strain relief clamp with grommet seal away from

connector.

(2) Tag and unsolder connector wires.

b. Replacement. Replace cable connector as follows:

(1) Clean off excessive solder from wire, and insert into contact until it bottoms out.

(2) Solder wire to connector pin.

(3) Slide strain relief clamp with grommet seal on connector, and tighten two screws.

3-36