Section IV. MAINTENANCE

TM 11-7010-201-40-1/ET821-AA-MMI-010/E154 MTS/TO 31S5-2TSQ73-2-1

Section IV. MAINTENANCE

3-10. Introduction. This section provides removal, replacement, and repair procedures for those items authorized for

General Support maintenance.

WARNING

HIGH VOLTAGE is used in the operation of this equipment. DEATH ON CONTACT

may result if personnel fail to observe safety precautions. Learn the areas containing

high voltage in each piece of equipment. Be careful not to contact high voltage

connections when installing or operating this equipment.

Before working inside the equipment, turn power off and ground points of high potential

before touching them.

3-1 1. MTS Component Access. Perform the following procedure to gain access to MTS internal components (figure

a. Extention Extend MTS as follows:

(1) Release eight captive screws securing front panel to case.

WARNING

When extending the MTS, always provide support for both the MTS and the case.

Extension of the MTS causes an unbalanced condition and the assembly may tip forward

causing personnel injury and equipment damage.

(2) Slowly slide frame out of case until slide locks engage.

b. Retraction Retract MTS as follows:

(1) Release slide locks and carefully slide frame into case.

(2) Secure front panel to case using eight captive screws.

3-17