 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 CHAPTER 1
Section I. GENERAL
but at less than rated capability or ef-
1. Scope
ficiency).
(4) Equipment improvement suggestions
AN/ASM-101 (fig. 1) and covers its operation
or recommendations.
and first and second echelon maintenance.
b. Report of Damaged or Improper Ship-
b. The maintenance allocation chart (MAC)
ment. Fill out and forward DD Form 6 ( Re-
for Test Set, Resolver AN/ASM-101 appears
port of Damaged or Improper Shipment), as
in appendix II; the basic issue items list (BIIL)
p r e s c r i b e d in AR 700-58 (Army), NAV-
appears in appendix III.
SANDA Publications 378, and AFR 71-4 (Air
Note. Refer to DA Pam 310-4 to determine what
Force).
changes to or revisions of this publication are current.
c. Reports of Comments on Maintenance Al-
2. Forms and Records
location Chart (Appx II) and Basic Issue Items
a. Reports of Unsatisfactory Equipment.
Form 2028 (Recommended Changes to DA
Fill out DA Form 2407 (Maintenance Request)
Technical Manual Parts Lists or Supply Man-
in accordance with instructions in TM 38-750
uals 7, 8, or 9) direct to: Commanding Officer,
and forward it to: Commanding Officer, U.S.
U . S . Army Electronics Materiel Support
Army Electronics Materiel Support Agency,
Agency, ATTN: SELMS-ML, Fort Monmouth,
A T T N : SELMS-PIE, Fort Monmouth, N.J.
N.J.
The form should be filled out and forwarded to
report :
d. Comments on Manual. Forward all other
comments on this publication direct to: Com-
(1) Receipt of defective equipment (use
manding Officer, U.S. Army Electronicx Mate-
DD Form 6 (b below) if defect is due
riel Support Agency, ATTN: SELMS-MPP-4,
to damaged or improper shipment).
Fort Monmouth, N.J. (DA Form 1598. (Record
(2) Equipment deficiencies (deadlined
of Comments on Publications), DA Form 2028,
equipments).
DD Form 96 (Disposition Form), or letter may
(3) Equipment shortcomings (operable,
be used.)
Section II. DESCRIPTION AND DATA
4. Technical Characteristics
a. Test Set, Resolver TS-1810/ASM-101.
101 provides a means of interconnecting test
Input signal requirements:
equipment and controlling the phase and ampli-
For ORZ procedure . . . . Reference phase 30 cps
tude of signals used in the alignment of resolv-
1%, 4.5 to 8 volts.
ers in aircraft navigational systems.
For calibration:
Reference phase . . 30 cps l%, 3 to 7 volts
b. Use. Test Set, Resolver AN/ASM-101 is
Variable phase . . ..30 cps 1%, 1.5 volts,
used with the additional equipment required
phase variable 0 to
180.
Environmental operating limits:
Computer Set, Navigational AN/ASN-33) for
Temperature . . . . . . -30 to 55 c. (-22 to
alignment to the standard omnirange zeroing
131 F.).
(ORZ) point, and align them to the ORZ point,
Relative humidity. . 0 to 95% at 32 C. (90
when necessary.
F.).
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals