APPENDIX C. COMPONENTS OF END ITEM LIST

TM 11-6625-3024-14/EE641-AC-MMA-010/E154 SYSEX/TO 33AA50-5-1-1

APPENDIX C

COMPONENTS OF END ITEM LIST

Section I. INTRODUCTION

(2) Item Number. The number used to

C-1. Scope. This appendix lists integral

identify item called out in the illustration.

components of and basic issue items for the TS-

b. National Stock Number. Indicates the

4002/UYH-5 to help you inventory items required

National stock number assigned to the item and

for safe and efficient operation.

which will be used for requisitioning.

C-2. General. This Components of End Item List

c. Part Number. Indicates the primary number

is divided into the following sections:

used by the manuacturer, which controls the

a. Section II. Integral Components of the End

design and characteristics of the item by means of

Item. These items, when assembled, comprise the

its engineering drawings, specifications, standards,

TS-4002/UYH-5 and must accompany it whenever

and inspection requirements to identify an item or

it is transferred or turned in. The illustration will

range of items.

help you identify these items.

d. Description. Indicates the Federal item name

b. Section III. Basic Issue Items. These are the

and, if required, a minimum description to identify

minimum essential items required to place the TS-

the item.

4002/UYH-5 in operation, to operate it, and to

e. Location. The physical location of each item

perform emergency repair. Although shipped

listed is given in this column. The lists are designed

separately packed they must accompany the TS-

to inventory all items in one area of the major item

4002/UYH-5 during operation and whenever it is

before moving on to an adjacent area.

transferred between accountable officers. The

f. Quantity Required (Qty Reqd). This column

illustrations will assist you with hard-to-be-identify.

lists the quantity of each item required for a

items. This manual is your authority to requisition

complete major item.

r e p l a c e m e n t BII, based on TOE/MTOE

g. Quantlty. This column is left blank for use

authorization of the end item.

during an inventory. Under the Rcv'd column, list

the quantity you actually receive on your major

C-3. Explanation of Columns.

item. The Date columns are for your use when you

a. Illustration. This column is divided as follows:

inventory the major item at a later date; such as for

(1) Figure Number. Indicates figure number

shipment to another site.

of the illustration on which the item is shown.

C-1