Column Entries. - TM-11-6625-3023-140051

TM 11-6625-3023-14/ET904-AA-MMA-010/E154 TS3684/TO 33A1-12-1173-1

Operator/Crew

Army. Overhaul does not normally return a to like new

Organizational

condition.

Rebuild.

Direct Support

Consists of those services/actions

General Support

necessary for the restoration of unserviceable

Depot.

equipment to a like new condition in accord with original

manufacturing standards. Rebuild the highest degree of

e. Column 5, Tools and Equipment. Column 5

materiel maintenance to Army equipment. The rebuild

operation the act of returning to zero those age

specifies, by code, those common tool sets (not

measurements (hours, miles, etc.) considered(

individual tools), and special tools, test, and support

classifying Army equipments/components.

equipment required to perform the designated function.

f. Column 6, Remarks. Column 6 contains an

B-4.. Column Entries.

alphabetic code which leads to the remark in Section IV,

Remarks, which is pertinent to the item opposite the

a. Column 1, Group Number. Column 1 group

particular code.

numbers, the purpose of which is to identify

B-5.

Tool and Test Equipment Requirements

components, assemblies, subassemblies, and modules

(Section III).

with the next higher assembly.

b. Column 2, Component/Assembly. Column 2

a. Tool or Test Equipment Reference Code. The

contains the noun names of components, assemblies,

subassemblies, and modules for which maintenance is

numbers in this column coincide with the numbers used

authorized.

in the tools and equipment column of the MAC. The

c. Column 3, Maintenance Function. Column 3 lists

numbers indicate the applicable tool or test equipment

the functions to be performed on the item listed in

for the maintenance functions.

b. Maintenance Category. The codes in this column

Column 2. When items are listed w maintenance

functions, it is solely for the purpose of having the group

indicate the maintenance category allocated the tool or

numbers in the MAC a RPSTL coincide.

test equipment.

d. Column 4, Maintenance Category. Column 4

c. Nomenclature. This column lists the noun name

specifies by the listing of a worktime figure appropriate

and nomenclature of the tools and test equipment

subcolumn(s), the lowest level o maintenance

required to perform the maintenance functions.

d. National/NA TO Stock Number. This column lists

authorized to perform the fun listed in Column 3. This

figure represents the time required to perform that

the National/NATO stock number of the specific tool or

maintenance function at the indicated category of

test equipment.

e. Tool Number. This column lists the manufacturer's

maintenance If the number or complexity of the tasks

within listed maintenance function vary at different

part number of the tool followed by the Federal Supply

maintenance categories, appropriate worktime figures

Code for manufacturers (5digit) in parentheses.

will be shown for each category. The number of task-

B-6. Remarks (Section IV).

hours specified by the work figure represents the

average time required restore an item (assembly,

subassembly, con module, end item or system) to a

Reference Code.

This code refers to the

serviceability condition under typical field operating

appropriate item in Section II, Column 6.

conditions.

This time includes preparation time,

b. Remarks. This column provides the required

troubleshooting time, and quality assurance, control time

explanatory information necessary to clarify items

in addition to the time require( perform the specific tasks

appearing in Section II.

identified for the maintenance functions authorized in

the maintenance allocation chart.

Subcolumns of

Column 4 are as follows:

B-2