CHAPTER 2. SERVICE UPON RECEIPT AND INSTALLATION

TM 11-6625-3023-14/ET904-AA/MMA-010/E154 TS3684/TO 33A1-12-1173-1

CHAPTER 2

SERVICE UPON RECEIPT AND INSTALLATION

Section I. SERVICE UPON RECEIPT OF MATERIAL

2-1.

Unpacking. No special instructions are required for unpacking the test set. Remove the test set from its

shipping container and perform the inspection given in paragraph 2-2.

2-2.

Checking Unpacked Equipment.

Inspect the equipment for damage incurred during shipment. If equipment has been damaged, report the

damage on SF 364 (para 1-3b).

Check the equipment against the component listing on the packing slip to see if the shipment is complete.

Report all discrepancies in accordance with paragraph 1-3c. The equipment should be placed in service

even though a minor assembly or part that does not affect proper functioning is missing.

Check to see whether the equipment has been modified. Equipment which has been modified will have the

MWO number on the front panel near the nomenclature plate. Refer to DA Pam 310-14 to see whether all

currently applicable MWOs have been applied.

Section II. INSTALLATION INSTRUCTIONS

2-3.

Introduction. The electric surge arrestors (ESA) test set is a portable, self-contained test unit which does not

require permanent installation. The test set is used prior to the operation of equipment that has been relocated, and

periodically at specific predetermined intervals. This section contains the procedure for interconnection of the ESA test

cables and preliminary checks of the test set. No special tools or test equipment are required.

2-4.

Test Set Preliminary Check.

Place the unit on a level surface which will allow the operator sufficient access to perform his functions.

Depress the pressure relief valve located on the front of the equipment case (fig. 1-1), before opening lid,

to equalize internal and external pressures.

Release the two front latches and lift the hinged lid.

Perform test operating instructions described in chapter 3.

2-5.

Electrical Interconnection. The three test cables located in the cover compartment are supplied to test the

bulk, coaxial, or end of wir (EOW) line type ESA devices. Refer to chapter 3, section II, Operation for the electrical

interconnection to the particular ESA to be tested.

2-1/(2-2 blank)