Section I. INTRODUCTION - TM-11-6625-1711-24P-10005

TM 11-6625-1711-24P-1

SECTION I

INTRODUCTION

entered in the tit and second positions of the

1. Scope

Uniform SMR Code format as follows:

Definition

This manual lists spares and repair parts; special

Code

tools; special test, measurement, and diagnostic

PA--Item procured and stocked for anticipated or

equipment (TMDE), and other special support equip-

known usage.

ment required for performance of organizational,

XB-Item is not procured or stocked. If not available

direct support, and general support maintenance of

through salvage, requisition.

the AN/APM-245A. It authorizes the requisitioning

XD-A support item that is not stocked. When

and issue of spares and repair parts as indicated by

required, item will be procured through normal

the source and maintenance codes.

supply channels.

NOTE

2. General

Cannibalization or salvage maybe used as a

source of supply for any items source coded

This Repair Parts and Special Tools List is divided

above except those coded XA and aircraft

into the following sections:

support items as restricted by AR 700-42.

a. Section II. Repair Parts List. A list of spares

and repair parts authorized for use in the perfor-

(2) Maintenance code. Maintenance codes are

mance of maintenance. The list also includes parts

assigned to indicate the levels of maintenance autho-

which must be removed for replacement of the

rized to USE and REPAIR support items. The

authorized parts. Parts lists are composed of func-

maintenance codes are entered in the third and fourth

tional groups in numeric sequence, with the parts in

positions of the Uniform SMR Code format as follows:

each group listed in figure and item number

(a) The maintenance code entered in the third

sequence.

position will indicate the lowest maintenance level

b. Section III. Special Tools List. Not applicable.

authorized to remove, replace, and use the support

c. Section IV. National Stock Number and Part

item. The maintenance code entered in the third

Number Index. A list, in National item identification

position will indicate one of the following levels of

number (NIIN) sequence, of all National stock num-

maintenance:

Application/Explanation

bers (NSN) appearing in the listings, followed by a

Code

list, in alphameric sequence, of all part numbers

O-Support item is removed, replaced, used at the

appearing in the listings. National stock numbers and

organizational level.

part numbers are cross-referenced to each illustration

H-Support item is removed, replaced, used at the

figure and item number appearance.

general support level.

(b) The maintenance code entered in the fourth

position indicates whether the item is to be repaired

3. Explanation of Columns

and identifies the lowest maintenance level with the

a. Illustration. This column is divided as follows:

capablity to perform complete repair (i.e., all autho-

(1) Figure number. Indicates the figure number

rized maintenance functions). This position will con-

of the illustration on which the item is shown.

tain one of the following maintenance codes:

Applcation/Explanation

Code

(2) Item number. The number used to identfy

H--The lowest maintenance level capable of complete

item called out in the illustration.

repair of the support item is the general support

b. Source, Maintenance, and Recoverability

level.

(SMR) Codes.

Z-Nonreparable. No repair is authorized.

(1) Source code. Source codes indicate the man-

(3) Recoverability code. Recoverability codes are

ner of acquiring support items for maintenance,

assigned to support items to indicate the disposition

repair, or overhaul of end items. Source codes are