Section I. INTRODUCTION - TM-11-6625-1704-24P0003

TM 11-6625-1704-24P

SECTION I

INTRODUCTION

support items to indicate the manner of acquiring support

Scope

items for maintenance, repair, or overhaul of end items.

Source codes are entered in the first and second

This manual list repair parts and special tools required

positions of the Uniform SMR Code format as follows:

for performance of organizational, direct support, and

general support maintenance of the AN/ASM338.

Code

Definition

PA Item procured and stocked for anticipated or

General

known usage.

This Repair Parts and Special Tools List is divided into

Item is not procured or stocked be cause the

the following sections:

requirements for the item will result in the

replacement of the next higher assembly.

a Section II-Repair Parts List. A list of repair

parts authorized for use in the performance of

A support item that is not stocked. When

maintenance. The list also includes parts which must be

required, item will be procured through normal

removed for replacement of the authorized parts. Parts

supply channels.

lists are composed of functional groups in ascending

numerical sequence, with the parts in each group listed

NOTE

in figure and item number sequence.

Cannibalization or salvage may be used as a

source of supply for any items source coded

b. Section III Special Tools List. Not

above except those coded XA, XD, and aircraft

applicable.

support items as restricted by AR 70042.

c. Section IV National Stock Number and Part

(2) Maintenance code. Maintenance codes are

Number Index. A list, in ascending National item

assigned to indicate the levels of maintenance

identification number (NIIN, last 9 digits) sequence, of all

authorized to USE and REPAIR support items. The

National stock numbers appearing in the listings,

maintenance codes are entered in the third and fourth

followed by a list, in alphanumeric sequence, of all part

positions of the Uniform SMR Code format as follows:

numbers appearing in the Listing. National stock number

and part numbers are cross-referenced to each

(a) The maintenance code entered in the third

illustration figure and item number appearance.

position will indicate the lowest maintenance level

authorized to remove, replace and use the support item.

Explanation of Columns

The maintenance code entered in the third position will

indicate one of the following levels of maintenance:

The following provides an explanation of columns found

in the tabular listings:

Code

Application/Explanation

Illustration.

This column is divided as

Support item is removed, replaced, used at the

follows:

organizational level.

(1) Figure number. Indicates the figure number

Support item is removed, replaced, used at the

of the illustration in which the item is shown.

general support level.

(2) Item number. The number used to identify

(b) The maintenance code entered in the fourth

each item called out in the illustration.

position indicates whether the item is to be repaired and

identifies the lowest maintenance level with the capability

b. Source, Maintenance, and Recoverability

to perform complete

Codes (SMR).

(1) Source code. Source codes are assigned to