|
| |
TM 1-6625-736-13 & P
APPENDIX E
MANUFACTURED ITEMS LIST
E-1 GENERAL
E-1
This appendix contains the procedures for fabricating the manufactured items you are authorized to make.
E-2 WIRING - MANUFACTURE
E-2
This task covers:
Fabrication
INITIAL SETUP
Personnel Required
TMDE Support Specialist
FABRICATION:
NOTE
Be sure the wire you cut is the same gage as the wire you are replacing. Identify wire by
using color coded tape, the same color as the wire you are replacing.
(1)
Cut a suitable length of wire from a spool of bulk wire.
(2)
Note what type and size of connector the old wire had and match them for the new wire.
(3)
Measure the length of the old wire. When cutting the new wire, add 6 in. to this length.
NOTE
If splicing a wire, use heat shrink tubing over spliced area.
(4)
Fasten the first connector splice to one end of the wire.
NOTE
Check new wire for continuity before installation.
(5)
Install the wire, following the path of the old wire as much as possible.
E-1
|
