|
| |
TM 1-4920-458-13&P
4-38.
REMOVE AND REPLACE POWER CONNECTOR (Cont)
(Sheet 2 of 2)
4-38.1. REMOVAL
a.
Remove connector cap (1) from power connector (2).
b.
Remove four mounting screws (3) four nuts (4) and four lock washers (5) from power connector (2).
c.
Remove power connector (2) from chassis (6) to access wires (7).
d.
Tag wires (7) and remove heat shrink (D2).
e.
Unsolder wires (7) from connector solder cups (8) and remove power connector (2).
4-38.2. INSTALLATION
a.
Slide heat shrink (D2) onto wires (7).
b.
Using solder (D5), solder wires (7) to connector solder cups (8) and place heat shrink (D2) over connector
solder cups (8).
c.
Install heat shrink (D2).
d.
Install power connector (2) in chassis (6) with key way pointing up, and secure with four mounting screws (3),
four lockwashers (5) and four nuts (4).
e.
Install cap (1) on power connector (2).
4-38.3. FOLLOW ON MAINTENANCE
Performance check (para. 2-5)
END OF TASK
4-53
|
