|
| |
TM 1-4920-458-13&P
SECTION CONTENTS (CONT)
PARA
PAGE
REMOVE AND REPLACE EMI FILTER
4-37
4-50
REMOVE AND REPLACE POWER CONNECTOR
4-38
4-52
REMOVE AND REPLACE DIODE PLATE
4-39
4-54
REPAIR WIRING HARNESS
4-40
4-56
REMOVE AND REPLACE OIL RESERVOIR AND/OR FILL AND RUN
SELECTOR VALVE
4-41
4-58
REMOVE AND REPLACE RIGID PRESSURE LINES (TYPICAL)
4-42
4-60
REMOVE AND REPLACE CHECK VALVES
4-43
4-62
REMOVE AND REPLACE SOLENOID VALVES
4-44
4-64
REMOVE AND REPLACE BELLOWS
4-45
4-66
4-15. MAINTENANCE PROCEDURES - GENERAL
When a maintenance procedure is required, it usually will involve removal of the part being repaired or replaced.
Removal procedures are given only to the extent necessary to repair or replace authorized parts. Fill panels are opened
or removed using flat-tipped screwdriver and turning fasteners counterclockwise.
4-16. PITOT AND STATIC SYSTEMS TESTER CALIBRATION
Maintenance of the Pitot and Static Systems Tester consists of periodic recalibration. Calibration cannot be performed at
AVIM level because a calibrated pressure/vacuum test gauge is required.
4-9
|
