|
| |
TM 1-4920458-13&P
Section IV. Troubleshooting
SECTION CONTENTS
PARA
PAGE
GENERAL
4-11
4-5
PITOT AND STATIC SYSTEMS TESTER
INSPECTION/FAULT ISOLATION
4-12
4-5
TROUBLESHOOTING PROCEDURE 1: MOTOR AND/OR INDICATOR LAMP
DOES NOT TURN ON
4-13
4-6
TROUBLESHOOTING PROCEDURE 2: TESTER DOES NOT BUILD OR HOLD
PRESSURE (AIRSPEED/VACUUM ALTIMETER)
4-14
4-7
4-11. GENERAL
A list of possible failures to the Pitot and Static Systems Tester as well as probable cause and corrective action are
shown in the following fault isolation block diagrams. Corrective actions, as shown in the following trouble shooting
diagram, are outlined in the applicable removal/replacement paragraphs in the text of this manual.
4-12. PITOT AND STATIC SYSTEMS TESTER INSPECTION/FAULT ISOLATION
Personnel Required:
35H Test, Measurement Diagnostic Equipment
(TMDE) Support Specialist
Tools/Test and Support Equipment:
Tool Kit (B2) or Shop Set (B4)
Equipment Conditions:
Tester on work bench
4-5
|
